| 
				 Re: Campaign thunder in the sinai" 
 Great hints chap, I usually run soviets equipped forces, so these woul be usefull also in other battles.
 Well, I finished the battle in a draw, and the campaign was over after this battle, I found it very challenging and maybe I could re-do it.
 To be honest I have destroyed a lot of Israeli tanks and troops, they were badly mauled when the battle finished; also my guys, mainly tanks, were in a bad status.
 
 My force was:
 Full coy of T62
 Full mech coy on OT62 with guns
 Mech support coy with malyutkas, rpg and etc
 2 engi sect on OT62
 4 zsu 57-2
 Varius
 
 A little recap: I left the chinese farm unguarded and rushed the ATGM armed infantry in the center, switching of the ATGMs; in the meantime T62 sneak alog a low cresr to reach the suez cuttings
 The battle go pretty straight, I use ATGMs only with 60% or more hit probability and keep T62 behind the crest ready to flank the Israeli tanks.
 
 Now the problem...my tankers, also my experienced T62, can't it a barn in the middle of nowhere, I pop-up them from the crest achiving a couple of good kill against Pattons, then they start to hit no-one, in commanded fire nor in overwatch fire,nothing.
 The move was smart and ,with a slightly better fire control or better crews, it would have been a winning blow...but it was not, I lose all my T62...
 
 A couple of question:
 
 How can I filter the objective for my weapons?
 Is it possible to save Sabot or Heat ammo?
 I totally don't understand how the close assault work ( but the Israeli know...coz they burn a lot of things'
 
			
			
			
			
				  |