Strategic Combat bug

Elmo · #1 June 26th, 2001, 06:55 PM

Fought another missile fleet vs planet battle and this time even with both movement strategies set to max range my ships blundered in too close (i.e. closer than max range) and got hammered. A bug IMO.

Elmo

Seawolf · #2 June 27th, 2001, 12:20 AM

Elmo,

Remeber the stratagies are based upon your target. If you have max range it will be max range from the planet. If the moon is farther out then you will get closer to it than max range. Not a bug persay, you need to clear moon first then planet or play with the straygy setting as far as what gets attacked first,

------------------
Seawolf on the prowl

Q · #3 June 27th, 2001, 11:41 AM

Elmo did you check the target priorities?
If "largest" or "nearest" is at the top it may explain what you observed. But if "has weapons" is at the top and your ships still ignore the moon with the weapon platforms then you have found a bug IMO.

geoschmo · #4 June 27th, 2001, 03:49 PM

Instead of moving in to the sector by using the attack button and then selecting one of the planets, simply use the move too button and click on the sector. This should allow it to attack both planets without ignoring either.

Geoschmo

Elmo · #5 June 27th, 2001, 04:36 PM

Seawolf

In the first battle where I noticed the problem, the planet was closer than the moon. My ships initially stayed out of range of the planet, thus also out of range of the moon. As I mentioned, after the planet defenses were reduced my ships moved closer to the planet while continuing to fire on it. That brought them in range of the moon too. However in that battle I had the secondary movement strategy set to point blank (the default) so that may have caused them to move in.

In my Last battle there was only one planet and my ships ignored both sprimary and secondary orders to stay at max range and moved closer. I had a 2 "square" range advantage over the planet defenses so they should never have hit me, but they did when my ships moved too close.

Elmo

Elmo · #6 June 27th, 2001, 04:40 PM

Q

I used the default target priorities. Don't have the game up right now and I can't recall the default. However as I said in my Last battle there was only one planet and my ships still moved closer than max range.

Elmo

Elmo · #7 June 27th, 2001, 04:43 PM

geoschmo

Can't recall if I used attack or move as the command to enter the sector, but I've never seen a choice presented for what to attack. Once my ships arrive, strategic combat has always been automatic, at least in PBEM games.

Elmo